Albumin-mediated asymmetric nitroaldol reaction of aromatic aldehydes with nitromethane in water

We succeeded in the asymmetric nitroaldol (Henry) reaction of aromatic aldehydes with nitromethane using human serum albumin (HSA) in water at neutral pH. The reaction of 4-nitrobenzaldehyde smoothly proceeded for 24 h at 30 °C to afford the corresponding (R)-2-nitro-1-(4-nitrophenyl)ethanol (27% ee). Lowering the reaction temperature to 0 °C improved the enantioselectivity (53% ee). Although the denatured HSA also catalyzed the coupling reaction, no enantioselectivity was observed. The reaction was also applicable to other substrates bearing various substitutions on the benzene ring, and the ee of (R)-1-(biphenyl-4-yl)-2-nitroethanol was up to 79% ee.     

大孔Mo-Ni/Al_2O_3催化剂的催化裂化柴油加氢性能研究

采用三次纳米自组装合成法,制备了一种以二次纳米自组装Al2O3为主体的大孔主客体催化剂FA-40,具有0.78 cm3·g-1的孔容、114 m2·g-1的比表面积、27 nm的平均孔径、6.0 nm和40 nm的双峰孔结构、孔分布在10~100 nm高度集中、低堆积密度为0.56 g·cm-3、活性金属含量高达35.70%。XRD和TEM分析结果显示,活性金属以直径小于2 nm的微晶态纳米粒子形式均匀分散于主体表面。采用劣质催化裂化柴油进行20 h加氢实验评价,反应趋于稳定时,FA-40的脱硫、脱氮及芳烃饱和率分别达到94.4%、95.5%和67.9%,与F-5相比分别提高了20%、80%和140%。300 h的长周期加氢实验表明,FA-40具有良好的加氢性能。     

过渡金属/氮掺杂石墨的制备及电催化氧还原

用简单的化学方法制备了过渡金属(TM)壳聚糖水杨醛席夫碱配合物,然后以此配合物为金属源和N源、以硝酸预处理石墨为载体,经热处理后制备了过渡金属/氮掺杂石墨催化剂TM-N-C-t(TM=Co,Ni,Cu;t=200,400,600,800,1 000℃).以此催化剂为修饰剂制备了玻碳修饰电极,并用循环伏安法(CV)和旋转圆盘电极(RDE)伏安法研究了催化剂TM-N-C-t的电化学行为和电催化氧还原(ORR)的催化性能,催化剂的组成和结构采用TG,FT-IR,XRD,XPS等技术进行了表征.研究结果表明,催化剂TM-N-C-t对ORR均显示不同程度的催化活性,其中以1 000℃热处理的钴基催化剂Co-N-C-1000的催化活性最好,其活性已接近相同条件下的商用催化剂JM 20%Pt/C,催化活性位主要为Co—N—C.根据扩散控制的不可逆反应的循环伏安行为,计算得到了TM-N-C-t催化剂电催化ORR的动力学参数,并以此提出了氧还原催化反应的机理,在活性最好的催化剂Co-N-C-1000修饰电极上,氧气以4e转移途径被还原为水.     

具有不同活性中心的固体催化剂的失活模式

 An approach is suggested to distinguish different types of active sites responsible for different reactions on bifunctional catalysts. The model assumes a non-uniform vulnerability of active sites that depends on their location. Problems on the relationship between the dispersion of the active phase and selectivity are discussed. The effect of coke formation on the activity change of different sites is analyzed.     

Al2O3性质对加氢脱硫催化剂Co-Mo/Al2O3活性相形成的影响

以两种商用Al2O3为载体,制备了汽油选择性加氢脱硫催化剂Co-Mo/Al2O3,并采用红外光谱、X射线衍射、N2吸附-脱附、透射电镜、扫描透射-能谱和X射线光电子能谱等手段系统研究了载体物化性质对催化剂活性相形成的影响.结果表明,表面羟基数量少和结晶程度高的载体与活性金属间相互作用减弱,促进了Mo物种的硫化还原,使MoS2片晶的尺寸和层数增加,且其硫化态催化剂上CoMoS活性位更多,CoMoS/MoS2比更大,因而显著提高了相应Co-Mo催化剂加氢脱硫活性和选择性.     

介孔Al2O3负载PdO催化甲烷燃烧反应性能

采用浸渍法制备了介孔Al2O3(M-Al2O3)负载PdO催化剂,考察了其催化CH4燃烧反应性能.结果表明,以M-Al2O3为载体的PdO催化剂活性比普通Al2O3载体高得多,这很可能与M-Al2O3的孔道结构对PdO物种的限域作用有关.随着PdO/M-Al2O3催化剂焙烧温度的升高,甲烷催化燃烧活性先增加后降低,其中700oC焙烧的催化剂活性最高,400oC反应时CH4转化率为91%.此时Pd物种主要以PdO颗粒形式高度分散在载体的介孔孔道内,而高温焙烧时,Pd物种主要以Pd和PdO的混合晶相存在.尽管900oC焙烧制得的催化剂上CH4的转化率降低,但TOF值最大,这可能与该催化剂中同时存在金属Pd和PdO有关.     

The first example for the asymmetric synthesis of allenes by the Doering-LaFlamme allene synthesis with enantiopure cyclopropylmagnesium carbenoids

The reaction of lithium α-sulfinyl carbanion of enantiopure dichloromethyl p-tolyl sulfoxide with α,β-unsaturated carbonyl compounds gave optically active 1-chlorocyclopropyl p-tolyl sulfoxides having a carbonyl group with high asymmetric induction from the sulfur chiral center. Reduction of the carbonyl group followed by treatment with Grignard reagent, the 1-chlorocyclopropyl p-tolyl sulfoxides resulted in the formation of enantiopure allenic alcohols via the Doering-LaFlamme-type rearrangement of enantiopure cyclopropylmagnesium carbenoid intermediates. This is the first example for the asymmetric synthesis of allenes by the Doering-LaFlamme allene synthesis.     

Metabolite identification by liquid chromatography-mass spectrometry

Metabolite identification (Met ID) is important during the early stages of drug discovery and development, as the metabolic products may be pharmacologically active or toxic in nature. Liquid chromatography-mass spectrometry (LC-MS) has a towering role in metabolism research.This review discusses current approaches and recent advances in using LC-MS for Met ID. We critically assess and compare various mass spectrometers, highlighting their strengths and limitations. Citing appropriate examples, we cover recent LC and ion sources, isotopic-pattern matching, hydrogen/deuterium-exchange MS, data dependent analyses, MS^E, mass defect filter, 2D and 3D approaches for the elucidation of molecular formula, polarity switching, and background-subtraction and noise-reduction algorithms. A flow chart outlines a comprehensive strategy for Met ID, including a focus on reactive metabolites.     

不同活性焦载体对V2O5/AC催化剂脱硫活性的影响

活性焦载体的选择是制备高活性烟气脱硫催化剂的关键.以四种煤制活性焦(AC)为载体,制得了系列V2O5/AC催化剂.通过脱硫活性评价、催化氧化能力测试和孔结构分析表明,AC表面的高活性氧化位较少,担载V2O5使AC表面产生了新的高活性氧化位,其脱硫活性显著提高;V2O5在具有高比表面积和较大孔容的载体上分散性较好,能够形...     

自抗扰控制技术在捷联惯导动基座初始对准中的应用研究

提出并设计了应用自抗扰控制技术(ADRC)的捷联惯性系统动基座初始对准方案。通过数字仿真，将卡尔曼滤波与自抗扰控制的性能进行了详细的比较，证明该方法具有对准时间快，精度高，抗干扰能力强等特点。